After connecting a new server to interface Te 1/0/1 and configuring the port, you notice...

After connecting a new server to interface Te 1/0/1 and configuring the port, you notice that the device is only showing up in the default VLAN 1 as shown in the exhibit.

interface TenGigabitEthernet 1/0/1

fabric isl enable

fabric trunk enable

switchport

switchport mode trunk

switchport trunk allowed vlan add 10

switchport trunk tag native-vlan

spanning-tree shutdown

no shutdown

!

show mac-address-table:

VlanId Mac-address Type State Ports

1 1234.5678.90ff Dynamic Active Te 1/0/1

You did not enable tagging on the server and now need to alter the interface configuration to force all frames from the server to be tagged for VLAN 10.

Which interface configuration would allow untagged frames from the server to be on VLAN 10?