You are troubleshooting interface net3 and you enter the following sequence of commands: Your next...

If you are assigning a static IP address, use the following syntax:

# ipadm create-addr -T static -a address addrobj

where addrobj uses the naming format interface/user-defined-string, such as e1000g0/v4globalz.

Note:

create-addr [-t] -T static [-d] -a {local | remote}=addr[/prefixlen], ... addrobj

Creates a static IPv4 or IPv6 address on the interface specified in addrobj. If the interface on which the address is created is not plumbed, this subcommand will implicitly plumb the interface. The created static address will be identified by addrobj.

By default, a configured address will be marked up, so that it can be used as a source or destination of or for outbound and inbound packets.