The correct answer isC. In source inspection practice, actual dimensions that are measured and verified during fabrication are normally recorded on theshop traveleror manufacturing record because that document follows the item through production and captures the step-by-step evidence of completion, inspection, and acceptance. The traveler provides traceability by linking the work operation, the inspection point, the measured results, and the responsible production or quality personnel. For an API-style source inspector, this is important because dimensional verification must be tied to the manufacturing stage where the check was performed, not just summarized later.
Aredline drawingis generally used to mark design or drafting changes, corrections, or as-built revisions, not to serve as the primary inspection record for measured results. Areference drawingis simply the controlled drawing used for comparison. Astatus reportis a communication document summarizing inspection progress, findings, and concerns for the purchaser; it is not the normal controlled record for individual dimensional measurements.
Therefore, when the inspector verifies actual dimensions at the shop, those measured values belong in theshop traveler.
