Place the steps to set up remote replication on the Powerflex system in the correct...

The correct sequence of steps to set up remote replication on the PowerFlex system is as follows:

Install target PowerFlex system: Before replication can be set up, there must be a target system in place to receive the replicated data1.

Exchange root certificates: This is a security measure to ensure that communication between the source and target systems is secure1.

Add a Replication Peer: This involves configuring the target system as a replication partner in the source system’s configuration1.

Configure replication volumes: Finally, specific volumes on the source system are configured to replicate to the target system1.

Setting up remote replication in a PowerFlex system involves a series of steps that establish the necessary components and configurations for the replication process. The sequence begins with the installation of the target PowerFlex system, which will serve as the destination for the replicated data. Next, root certificates are exchanged between the source and target systems to ensure secure communication. The target system is then added as a Replication Peer within the source system’s configuration. Lastly, the volumes intended for replication are configured on the source system to complete the setup process. This sequence ensures that the replication is secure, reliable, and correctly configured to maintain data integrity and availability across both systems1.