A customer engineer has installed VS2 VPLEX hardware, assigned IPs, and made the VPLEX ready...

When using the EZ Setup wizard for VPLEX, the correct interface and port to SSH into is the Management Server’s eth1 interface. This is typically the interface configured for management access and is used during the initial setup process.

Management Server Access: The Management Server is the primary interface for managing and configuring the VPLEX system. It is through this server that the EZ Setup wizard is accessed1.

eth1 Interface: The eth1 interface on the Management Server is usually dedicated to management traffic. This interface is configured with an IP address that allows SSH access for configuration purposes1.

EZ Setup Wizard: The EZ Setup wizard is a guided setup tool that simplifies the initial configuration of the VPLEX system. It prompts the user for necessary information to configure the system1.

SSH Protocol: Secure Shell (SSH) is a network protocol used to securely access network services over an unsecured network. When configuring VPLEX, SSH is used to connect to the Management Server and run the EZ Setup wizard1.

Configuration Steps: To SSH into the Management Server, the customer engineer would use an SSH client, input the IP address assigned to the eth1 interface, and connect using the appropriate credentials provided during the VPLEX installation1.

In summary, to use the EZ Setup wizard for configuring VPLEX, the customer engineer should SSH into the Management Server using the eth1 interface. This interface is set up during the initial installation and is used for management access to the system.