Which TMSH command initiates a manual configuration synchronization to the specified device group?

In a BIG-IP Device Service Cluster (DSC), manual configuration synchronization is performed using the ConfigSync framework. The supported and documented command to manually push the local configuration to a specific device group is:

tmsh run cm config-sync to-group

This command:

Initiates a one-time manual ConfigSync

Pushes the local device’s configuration to all members of the specified device group

Is commonly used when auto-sync is disabled or when the administrator wants explicit control over synchronization timing

Why the other options are incorrect:

A is not a valid TMSH command for ConfigSync.

B enables auto-sync but does not perform an immediate synchronization.

D is not a valid or supported TMSH command for device group configuration synchronization.

Therefore, the correct command to manually synchronize configuration to a device group is C.

===========