What command should the Implementation Engineer run to configure a proxy?

FlashArrays require outbound HTTPS connectivity to reach Pure1 for log uploads, phone home, and remote assist. In many enterprise environments, direct internet access is blocked, and traffic must be routed through an HTTP/HTTPS proxy.

To configure this setting in Purity via the CLI, the correct command ispurearray setattr --proxyfollowed by the full proxy URL (including protocol and port). The setattr (set attribute) subcommand is the standard method for modifying array-wide configuration parameters like the array name, idle timeout, and proxy settings. The other command variations (puresetup proxy or purearray configure) are incorrect syntax for this specific operation. This configuration is often a critical step during the "Pre-Flight" or initial setup phase to ensure the array can "phone home" immediately upon deployment.

=========