ExhibitReferring to the exhibit, which two configuration changes must you apply for packets to reach...

A. On R1, enable Level 1 on the ge-0/0/1 interface.  In IS-IS, both levels (Level 1 and Level 2) are enabled by default when you enable IS-IS on an interface 1 .  Level 1 systems route within an area 2 .  If the destination is outside an area, Level 1 systems route toward a Level 2 system 2 . Therefore, enabling Level 1 on the ge-0/0/1 interface on R1 would allow packets to reach from R1 to R3.

D. On R3 enable Level 1 on the ge-0/0/4 interface Similarly, enabling Level 1 on the ge-0/0/4 interface on R3 would allow packets to reach from R1 to R3.

These explanations are based on the IS-IS configuration documents and learning resources available at Juniper Networks 1  and Cisco 3 4 .