A Juniper Networks EX Series Switch has storm control enabled on all interfaces.

When storm control on an EX Series switch is configured with an action of interface-shutdown (rather than the default of simply dropping excess traffic), exceeding the configured bandwidth threshold for broadcast, multicast, or unknown-unicast traffic causes Junos to administratively disable the offending interface to protect the rest of the switching fabric. Recovery from this condition can happen automatically if a recovery-timeout interval has been configured, but when immediate manual recovery is required, the operational command clear ethernet-switching recovery-timeout interface interface-name explicitly clears the storm-control-triggered violation and re-enables the port without waiting for the timer to expire. This command is purpose-built for this exact condition and is distinct from more general troubleshooting commands: clear ethernet-switching table purges the learned MAC address database and has no bearing on a storm-control-disabled port; clear interface statistics resets traffic counters for diagnostic baselining but does not touch administrative state; and clear log messages simply flushes the local system log buffer. Administrators should also verify the underlying cause of the storm — a switching loop, a misbehaving host, or a misconfigured device — before manually clearing the condition, since without addressing the root cause the port is likely to trip again. This command and workflow are commonly tested as part of the Layer 2 security and resiliency features on EX platforms. Reference topics: Junos Enterprise Switching – Storm Control and Port Security, Recovering Interfaces Disabled by Storm Control.