Which configuration steps will add untagged ethernet ports 1/1/1 and 1/1/2 and tagged ethernet port...

To configure RUCKUS ICX switch ports 1/1/1 and 1/1/2 as untagged members of VLAN 10, and port 1/2/1 as a tagged member of VLAN 10, follow these steps:

Access the Switch's Command Line Interface (CLI):

Use SSH or a direct console connection to access the switch's CLI.

Enter Global Configuration Mode:

At the prompt, enter:

bash

Copy code

enable

configure terminal

Create or Select VLAN 10:

Ensure VLAN 10 exists. If not, create it:

Copy code

vlan 10

Assign Ports 1/1/1 and 1/1/2 as Untagged in VLAN 10:

Within VLAN 10 configuration, assign the ports:

css

Copy code

untagged ethernet 1/1/1 to 1/1/2

Assign Port 1/2/1 as Tagged in VLAN 10:

Still within VLAN 10 configuration, assign the port:

Copy code

tagged ethernet 1/2/1

Exit Configuration Mode and Save Changes:

Exit to the previous mode:

bash

Copy code

exit

Save the configuration to ensure changes persist after a reboot:

arduino

Copy code

write memory

VLAN Configuration:

The command vlan 10 selects VLAN 10 for configuration. If VLAN 10 does not exist, this command creates it.

Untagged Ports:

The command untagged ethernet 1/1/1 to 1/1/2 assigns ports 1/1/1 and 1/1/2 as untagged members of VLAN 10. Untagged ports are typically used for end devices that do not tag their own traffic.

Tagged Ports:

The command tagged ethernet 1/2/1 assigns port 1/2/1 as a tagged member of VLAN 10. Tagged ports are commonly used for trunk links between switches or other network devices that handle multiple VLANs.

Command Syntax:

The sequence of commands in option D correctly follows the RUCKUS ICX switch configuration syntax, ensuring that the ports are appropriately assigned to VLAN 10.

References:

VLAN configuration on Ruckus ICX switches for Ruckus Wireless WLAN's

ICX 7150 tag port VLAN1 - RUCKUS Community Forums