In a room that measures 15 feet × 25 feet with the entire floor wet,...

The IICRC WRT guidance uses an initial air-mover recommendation based on affected surface area to support evaporation across wet materials. The WRT manual summarizes the S500-based starting method: (1) place one air mover for each affected area, then (2) add one air mover for every 50 to 70 square feet of affected floor area, and then consider additional adjustments for offsets/insets and other complexities as applicable.

Here, the room is a single affected area and the entire floor is wet. The floor area is 15 × 25 = 375 square feet. Using the WRT/S500 initial guidance, the floor-area addition is:

• High end: 375 ÷ 50 = 7.5 → round up to 8 air movers

• Low end: 375 ÷ 70 = 5.36 → round up to 6 air movers

Then include the “one per affected area” base air mover for the room. That yields an initial range of 7 to 9 total air movers (1 + 6 to 1 + 8). This matches the correct selection range.

The scenario also states wall wicking is minimal (less than 2 feet) and there are no offsets, so the wall-above-2-feet rule and offset additions do not apply in the initial count. The objective at this stage is continuous airflow across wet surfaces to maintain a low-humidity boundary layer at the material surface, supporting rapid evaporation. The WRT manual further notes that airflow needs vary by the amount of wet surface area, accessibility, and other field limitations, and professional judgment may require adjustment after monitoring confirms actual drying progress.

==========